|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
13-07-2016, 05:16 PM
|
#1 | ||
|
Regular Member
Join Date: Feb 2016
Posts: 187
|
I had mechatronic unit/TCM replaced in my Powershift a couple of months ago and the shifts now seem to be at significantly higher RPM than before.
I'm not quite sure how different it is because I only had the car a week before it went off for repair for a month. I swear it was much lower before though, especially 1st to 2nd which is now around 3000 under fairly sedate acceleration, which feels too high to me. I know some transmissions learn and adapt to how the car is driven so I thought the difference I'm noticing may have something to do with this and that it might return to 'normal' after a while. It hasn't. Anything I can or should do to get the transmission to learn after the repair? |
||
|
|
Powershift 'Learning' after repair
Threaded Mode