|
18-02-2015, 03:07 PM | #1 | ||
Starter Motor
Join Date: Dec 2009
Posts: 14
|
Trying to figure out if the plugs are attached in the correct order.
I can't find a photo anywhere of the correct order. I can find references on the internet to 1-3-4-2. I tried connecting them as 1-3-4-2, but perhaps I did it wrong as engine is shaking and making a lot of odd noise. Attached if a photo of order I used, based on the sequence 1-3-4-2 |
||
18-02-2015, 03:30 PM | #2 | ||
Starter Motor
Join Date: Dec 2009
Posts: 14
|
wait a minute.... should 1-3-4-2 be the order of the plugs on the cap (yellow numbers)
And the plugs on the actual engine (red numbers) be 1-2-3-4 ? Is that where I went wrong? |
||
18-02-2015, 04:12 PM | #3 | ||
Banned
Join Date: Mar 2010
Location: PERTH. WA
Posts: 4,697
|
1342 on the dissy so you just need to know where number 1 is on the dissy and the rotation of the dissy to work it out from there,numbers on the motor should read 1234 left to right,should always mark numbers when removing/replacing leads.
|
||
18-02-2015, 04:25 PM | #4 | ||
Guest
Join Date: Feb 2007
Location: Gods Country
Posts: 16,258
|
|
||
18-02-2015, 08:37 PM | #5 | ||
Starter Motor
Join Date: Dec 2009
Posts: 14
|
never mind... found the firing order in the repair manual. Got it connected properly this time and it runs smoothly.
|
||