|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Bar For non Automotive Related Chat |
|
|
Thread Tools | Display Modes |
25-08-2007, 06:16 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Aug 2006
Location: WA, Perth/ Pilbara
Posts: 2,473
|
Finished building my New exhaust for my Mid sized Quad bike to replace the chit factory unit.
It's a 250cc Pushrod OHV. The system is made out of 316 stainless steel, 31.6mm tube back into into a 3-inch Hollow Muffler then reduced down to 35mm Straight out the back, It's all fully Tig welded and internally Argon gas purged during welding to give a nice clean finish on the inside of all joins. Apart from being alot louder than i was expecting, and for a 250cc engine in my books it pumps out a fairly Kick A R S E sound, hear is a sound shot only revved it to half throttle , It a bit average as i took it off my phone. Link Cheers
__________________
FPV GS ute 5.0 S/C Twin 3-inch, pacemaker headers |
||
|
|
My new exhust
Threaded Mode